There are many types of stenter, but the basic structure is nothing more than the following combined components:
It is used to smoothly guide the fabric into the tenter, and generally consists of a plurality of cloth guide rollers, an edge suction device and a bracket with a roller.
There are two types of fabrics and needle boards. Generally, cotton and wool fabrics are used for needle boards, and silk are used for fabrics. They are used to fasten the cloth and make it easy to apply tension to both sides to flatten the cloth.
There are two types of open type and drying room type. Generally, cotton cloth is used in a closed oven type, and silk is used in an open type. It is heated by steam and sprayed to wet.
After passing through the needle plate or the fabric, the cloth edge will have a curved lotus leaf edge phenomenon. After ironing with a steam roller in the middle, this lotus leaf edge will be eliminated and at the same time at a higher temperature It can also relatively stabilize the size of the stretched door width, and at the same time can iron the cloth surface more flat and bright.
Cloth dropping device:
The tented cloth is passed through a series of guide rollers, and the cloth is rolled into a roll or dropped into the circulating car through an S-shaped swing to enter the next process.
Static elimination device
By means of tip discharge or positive and negative offset, the electrostatic conduction generated by ironing friction on the cloth surface is dissipated to prevent the accumulation of static electricity and affect the operation of workers.